Levamed stabili-tri

• Contains Rigid Material

The orthesis produces a stabilisation of the ankle joint, through the interplay of the knitted fabric, a rigid, medially running stabilisation element (plastically formable), the sturdy tongue and the strap system. The limiting of pronation, supination and of plantar flexion, protects the joint against further harm after a trauma. The knitted fabric on its own here produces a massaging effect that promotes the circulation and thus accelerates the decreasing of swellings and effusions. The strap system supports the body‘s own stabilisation and gives additional hold, similar to taping. Due to the fact that it can be downgraded, the Levamed stabili-tri orthesis is suitable for therapy accompaniment adapted to stages. The product can thus be downgraded according to the phase of the healing process and offer more freedom of movement in a controlled way. The orthesis can be worn with or without a stocking, as required.
1. Phase – acute phase (inflammation phase)
Immobilisation of the foot is absolutely necessary in order to counteract inflammations and marked swellings on the ankle occurring immediately after the injury. Fully equipped with stabilising element and strap system, this orthesis provides maximum support for relief and thus supports the reduction of swelling and pain.
2. Phase – repair phase (proliferation phase)
The mobilisation of the foot can be gradually increased, improving the muscular stabilisation of the ankle joint and assisting further reduction of swelling in the affected structures. By removing the stabilising elements, the ankle joint is given more freedom, permitting controlled movement. The combination of the stiff tongue and webbing continues to provide necessary support. In order not to re-injure structures that have healed during the day, it is however recommended to continue using the stiff element at night as well.
3. Phase - remodulation phase
In the final therapy phase, the webbing is removed to allow further freedom of movement. The aim is to continue to get the affected structures used to loads and strengthen them. The stiff tongue and the knitted fabric continue to support the body‘s own joint stabilisation proprioceptively.

Putting on the orthesis: Attach the middle of the strap to the front part of the bottom of the foot. Here one should ensure a marked trapezoid shape. This way, the strap end lies on the outer side of the foot and that the point symbols are visible. Now velcro-fasten the stabilisation element (thermoplastically formable) into the knitted fabric and make sure that it is fixed to the ground at the two velcro points and at the calf brace. Grip the orthesis from above at both sides and secure the stabilising element with the knitted fabric. Ensure that the orthesis is wide open and now pull it onto the foot until the heel lies properly in the shell. When closing the orthesis, please ensure that the tongue is under the knitted fabric, as with a conventional laced shoe. During lacing, the foot should be in a 90° position to the lower leg (depending on pain). Now close the orthesis. To do this, click the laces into the eyelets and fix at the end with a bow. Make sure that the orthesis fits tightly to the foot, but avoid any pinching of the foot caused by pulling too tightly. Now grasp the end of the strap lying to the outside of the foot. Guide this diagonally over the instep, backwards and upwards, and fasten it above the ankle on the fleece. Do the same with the second strap end, which is then fastened next to the first strap end. The length of the strap can be individually adapted by cutting to size. To do this open the velcro fastenings on the strap ends and cut the strap accordingly. Taking it off: First loosen the strap and the lacing. In order to make taking it off easier, please make sure that the orthesis is wide open. Hold the tongue with one hand, with the other grasp the knitted fabric and the stabilising element. Now push the orthesis down over the foot.